Tips to Clean Your AC Unit at Home
It’s true that the amount of air conditioning repair in Houston, Texas a homeowner can do on an AC is limited, but there are some practical and easy steps that can be performed to keep your air conditioner running smoothly and efficiently. Here is a step by step guide in maintaining your unit.
First, before you start cleaning your unit, make sure that you unplug the air conditioner to disconnect it from power.
Second, remove the filter and cover the AC in needed. Dismantle the filter from the unit to expose the cooling coils of the unit. Take note that some AC models may require the bezel or front cover to be fully removed in order to see all the components of the coil. Moreover, an AC cover is usually secured by screws, which means that they will only become visible after the filter is removed.
Third, use cleaning agent and spray over on the front coil of the unit. Most home depots and hardware stores sell these products to do this particular job. These cleaning agents are designed to remove odors that are caused by mildew, dirt, cigarette smokes, cigar, and mildew that have accumulated on the coils over time. Be careful in cleaning the coils with the cleaner and avoid the foam of the spray from contacting with the control pads, electrical parts and other sensitive components of the unit, visit http://aatempco.com/ services for additional info.
Fourth, clean the filter thoroughly. Use clean water to clean the filter and make sure to replace any missing part. Actually, it’s easier and less expensive to remove and clean the filter regularly than having your unit undergo and air conditioning repair in Houston, Texas. If you’re suspecting that the filter itself contributes to the odors, you can use special types of detergent or other cleaning agents to remove the bad odor.
Fifth, when you’re done cleaning the unit and the filter, replace the filter and the unit’s cover. Make sure that the covers are properly screwed and fastened. Restore the power after 15 minutes.
Sixth, run the unit and monitor its function. Set the AC first to “Cool” and set the thermostat to its coldest temperature. This will allow the warm and humid air to condense when it’s passing over the cold coils. The condensed air will remove the foam and dirt from the coals and dump them in the drip pan. Subsequently, the drip pan will drain outside the unit, however, only if the unit is installed properly which is its back is slightly tilted toward the ground.
Finally, repeat the process if necessary. This is especially true if the unit has been neglected for quite some time, which requires a another round of application and cleaning to produce cold and odor-free air.
Repeat if necessary. If the air-conditioner has been neglected, it may require a second application to produce cold air and be free of odors. Wait until the coils are free from foam before re-applying. If the unit makes cool air but fails to make condensate to wash the coils, it may be due to low of humidity. In low humidity conditions, it will take longer to rinse the coils. If the unit fails to make cool air, it has likely lost the refrigerant charge or the compressor has failed.
Click here for related articles:
- Understanding the Importance of Foundation Repair in Kansas City, MO
- Checklist of Expectations from Professional Houston, TX Air Duct Cleaning Company
- Kinds of Materials That You Can Use For Repairing Your Roof
- Reasons to Have Home Security System Installed in Your Home